|
Taco 222 Flo-Chek Valve - 1-1/2" IPS Cast Iron
|
Item Number: 8596
Manufacturer Name: Taco
Manufacturer Part No: 222
* Whole number only
|
|
Product Data and Manuals:
For more than 40 years, designers and installers have used Taco
Flo-Cheks in forced hot water heating systems to prevent gravity
circulation during periods when the boiler is hot, but the space
heating zone is not wanted. This makes it possible to use the heating
boiler to maintain domestic hot water year-round.
You can also use Flo-Cheks in systems with multiple circulator zones to
allow heat to flow only into the zones that are calling for heat. In
addition, the thumb screw can be opened manually for gravity feed
applications, if the main circulator stops operating.
Features Include:
- Automatically Opens When Circulator Starts Running
- Cast Iron, Universal Body or Bronze Sweat-In Configuration
- 125 PSI Maximum Operating Pressure (862 kPa)
- 277ÃÃú F Maximum Operating Temperature (136ÃÃú C)
222 Taco 1/2" Universal Flo-Chek
Frequently Asked Questions
|
Q.
|
Why
does my Flo-Chek leak by?
Typically this is caused
by debris accumulating on the disk or seat. This would be the case if the
valve worked fine when it was first installed. You will have to take the
valve apart and clean the seat, disk, and stem to bring the valve back to
original. The stem should be vertical.
|
|
Q.
|
Why
is my Flo-Chek or MPV noisy?
Normally a check valve is
noisy if the valve is oversized for the flow going through the valve. The
flow cannot lift or swing the disk all the way open so the disk bangs back
and forth within the body of the valve.
|
|
Q.
|
Why
does my hot water circulate when my Taco pump is off?
Something has adhered to
the Flo-Chek seat or disk. The Flo-Chek is a weighted disk check valve that
normally prevents thermosiphoning. That is, it prevents the lighter, hot
water from rising to the radiation and the heavier, cool water from sinking,
causing a flow in the system without a pump. If the system worked fine before
and then started to act up, the disk is stuck or something is on the seats.
|
|
Q.
|
My
house has five zones, each with its own circulator. Hot water is passing into
zones that are not calling for heat. Do I have some defective circulators?
If you are not using zone
valves, you need either Flo-Checks or a circulator with an Internal Flow
Check (IFC). This is required to prevent thermosyphoning, a condition
in which lighter, hot water rises, and heavier, cool water sinks, causing a
flow in the system.
|
|
Q.
|
I
have a 3-zone residential system with a 219 Flo-Chek on each zone. The manual
override thumb screws are all open ~2 turns. Should these be fully closed?
The bypass knob should be
turned clockwise all the way for normal operation. For bypass mode, thurn the
knob counterclockwise until you have reached the position desired.
|
|
Product Reviews
|
|
|