Honeywell S9200U1000 Universal Hot Surface Ignition Integrated Furnace Control

Features

• • Cross reference and wire harnesses provided for simple replacement over 195 existing furnace controls.
• Main burner ignition using a 120V hot surface igniter.
• Flame rectification circuit to monitor flame presence.
• Monitoring of system pressure switch, high temperature limit, and rollout functions.
• Appliance operation/safety requirements controlled via microprocessor.
• Controls circulating fan motor based on appliance requirements, in response to a conventional low voltage thermostat.
• LED system status, performance and diagnostic indication.
• Twinning capability

Product Specifications

• Application: Single stage warm air furnaces
• Frequency: 60 Hz
• Operating Humidity Range (% RH): 0% to 95% non-condensing
• Operating Temperature Range (F): -40 F to +175 F
• Operating Temperature Range (C): -40 C to +79 C
• Flame Failure Response Time (sec): 2 Seconds max @ 1µA
• PrePurge: 30 seconds
• PostPurge: 15 seconds
• Cool Fan On Delay: 5 seconds
• Cool Fan Off Delay: 0 or 60 seconds
• Line Voltage: 120 Vac (97-132 Vac)
• Low Voltage: 24V (18-30 Vac)
• Igniter Current: 5 A resistive @ 120VAC
• Thermostat Anticipator Setting: (Stage 1 only) 100mA
• HSI Warmup Time: 17/27 or 30/30 seconds
• Trial For Ignition: 4, 6, or 8 seconds
• Interpurge: 60 seconds
• Ignition Trials: Three, two tries if flame is not sensed
• Number of LEDs: 3
• Heat On Fan Delay: 30 or 60 seconds
• Heat Off Fan Delay: 60, 90, 120, or 180 Seconds
• Gas Control Used With: Any 24Vac redundant, direct ignition gas control rated at 1.5A or less. Honeywell VR8205 recommended.
• Cooling Contactor Used With: Any 24Vac contactor rated at 1.0A or less
• Induced Draft Blower Load: 2.2FLA / 25LRA max @120Vac
• Ciculator Load: 14.5FLA / 25LRA max @120Vac
• Type of Fan Used With: Standard Induction-Type Circulating Fan